Pull powder for a job

Record the powder you take from stock for a job.

How to do it

What this is for: taking powder out of inventory (or putting leftovers back) right from the job card, so stock stays accurate.

Steps

  1. On Jobs, find the job. Next to the color name is the powder you have in stock, e.g. Chassis Black Satin (40.00 lb), followed by + and −.
  2. Click + or −. A small Qty box opens with +, − and × (close) buttons.
  3. Type the pounds you're using (e.g. 2), then click − to take it out of stock.
  4. A message Stock Updated — Chassis Black Satin: 40 → 38 lb appears and the weight on the card changes.
  5. To put powder back, type the pounds and click + (message: 38 → 40 lb).
  6. Click × to close the box without changing anything.

Good to know

  • The weight on the card is the powder's total stock in Inventory, not how much this job uses. Every job card with that color shows the same number.
  • Changes show in the item's history in Inventory.
  • The powder's low-stock alert on the Dashboard uses the same number.

If something looks wrong

  • Pulled the wrong amount: enter the same number and click the opposite button (+ to put back, − to take out).
  • No + / − next to the color: the color on the job may not be linked to an inventory item; check the item exists in Inventory with the same name.

Transcript

  1. Next to the color, the card shows how much of that powder you have in stock.
  2. Click the plus or minus next to it. A small quantity box opens.
  3. Type how many pounds you're using, then click minus to take it out.
  4. Stock drops straight away, and you'll see the before and after.
  5. Got some left over? Enter it and click plus to put it back.

See it on a real shop floor

Open the demo shop — no signup, nothing to install — or start a free trial with your own jobs.