Move a job through the shop

Send a job from station to station as the work gets done.

How to do it

What this is for: recording where a job is on the floor, station by station (Intake, Prep, and so on), so everyone can see where it stands.

Steps

  1. On Jobs, find the job. The badge at the top right of the card says where it is, e.g. Waiting for Intake.
  2. Click the yellow Start button for that station (e.g. Start Intake). A Work started message appears and the badge changes to In Intake.
  3. When that station is done, click Advance. The message Moved to next station appears with an Undo button, and the badge changes to the next station (e.g. Waiting for Prep). The yellow button changes to that station's Start button (e.g. Start Prep).
  4. To move a job back one station, click Send Back (only works while the job is in a station, e.g. In Prep). The message Sent back to previous station appears, with Undo.
  5. If the coating failed, click the red Rework button. In Mark for Rework, choose Entire Job or Partial Rework, type a Reason for rework (required), and optionally pick Start rework at station (default: beginning).
  6. Click Send Entire Job for Rework when you're ready (or Cancel).

Good to know

  • Send Back is grayed out while a job is waiting for a station; start the station first.
  • The Undo button on the bottom-right message reverses the last Advance or Send Back.
  • With Waiting Periods turned on (Company Settings › Production), jobs wait before preheat, spray, cure and QC and need a Start click to enter those stations.
  • Mark Complete on the card finishes the job in one click (see "Mark a job complete").

If something looks wrong

  • No Start / Advance buttons, only Mark Complete: the shop is in Simple Mode. An owner or production manager can switch it in Company Settings › Production.
  • Rework button grayed out at the bottom of the window: the Reason for rework box is empty.
  • Clicked Advance by mistake: click Undo on the message right away, or use Send Back.

Transcript

  1. The badge shows where the job is waiting. Click Start when work begins.
  2. The badge now says In Intake, and the button becomes Advance.
  3. When this station's done, click Advance.
  4. Now it's waiting for Prep. Clicked by mistake? Hit Undo.
  5. Send Back moves it back one station if it went ahead too early.
  6. It's back in Intake.
  7. If the coat failed, click Rework, choose the parts, and say what went wrong.
  8. Pick where it starts over, then send it for rework.

See it on a real shop floor

Open the demo shop — no signup, nothing to install — or start a free trial with your own jobs.