Mark a job complete

Finish a job so it's ready to invoice.

How to do it

What this is for: marking a job finished in one step when your shop doesn't track each station.

Steps

  1. On Jobs, find the job. In Simple mode its card shows Mark Complete, Mark for Rework, Mark for Invoice, Schedule and Schedule Tomorrow.
  2. Click Mark Complete.
  3. A box asks Mark this job complete? Click Mark Complete again (or Cancel). A Job completed message appears.
  4. The job leaves the normal list. To see it, click Filters and pick Completed.
  5. A completed job has a green Completed badge and shows the date and time it was finished (e.g. Oct 17, 12:48 PM).
  6. To undo, click Mark Incomplete on the completed card. A Job marked incomplete message appears and the job goes back to the active list.

Good to know

  • Completed jobs show up under Filters › Needs Invoice until they're billed.
  • Completed jobs move to the archive after the number of days set under Company Settings › Production › Job Retention (30 days by default). Archived jobs can still be searched and restored.
  • In Tracking mode, the card also has Mark Complete, next to the station buttons.

If something looks wrong

  • "My job disappeared": it was marked complete. Filters › Completed, then Mark Incomplete if needed.
  • No Mark Complete button: check you're looking at an active job, not one already completed.

Transcript

  1. When a job's finished, click Mark Complete on its card.
  2. PowderFlow double-checks. Click Mark Complete again.
  3. Finished jobs leave the main list. Use the Completed filter to see them.
  4. The badge turns green and shows when it was finished.
  5. Done too soon? Click Mark Incomplete to put it back.

See it on a real shop floor

Open the demo shop — no signup, nothing to install — or start a free trial with your own jobs.