Get jobs ready to invoice

Gather finished jobs so they're ready to bill.

How to do it

What this is for: keeping a clear list of jobs that need billing, so finished work doesn't go unbilled.

Steps

  1. On Jobs, click Mark for Invoice on a job's card. The button changes to ✓ Unmark for Invoice and the card's left edge turns teal. A job doesn't have to be finished to be marked.
  2. Click Filters and pick Needs Invoice under Status.
  3. The list shows jobs marked for invoice first, then completed jobs that haven't been billed yet. A chip shows Status: Needs Invoice.
  4. The count at the top (e.g. 31 of 76 jobs · filtered) is how many jobs are waiting to be billed.
  5. Tick the jobs you're billing (box at the top-left of each card). In the bar that appears (1 selected), click Invoice when you're ready.

Good to know

  • Completed jobs show up under Needs Invoice even if nobody clicked Mark for Invoice.
  • The job's Invoice # can be typed in Edit (pencil) and shows on the job as Not invoiced yet until it's filled in.
  • To take a job off the list, click Unmark for Invoice.
  • The Invoice button acts on every ticked job; check the selection count first.

If something looks wrong

  • The message says "Job unmarked for invoice" right after marking: go by the button. Unmark for Invoice means the job IS marked.
  • A billed job is still on the list: check its Invoice # is filled in.

Transcript

  1. When a job's ready to bill, click Mark for Invoice on its card.
  2. Then click Filters and pick Needs Invoice.
  3. Marked jobs come first, then finished jobs that haven't been billed.
  4. The count at the top shows how many are waiting.
  5. Tick the jobs you're billing, then click Invoice when you're ready.

See it on a real shop floor

Open the demo shop — no signup, nothing to install — or start a free trial with your own jobs.