Quick actions on a job card
Do the everyday things right from the job card.
How to do it
What this is for: marking a job for invoicing or putting it on a day, straight from the Jobs list, without opening the job.
Steps
- On Jobs, find the job card. The bottom row has Mark for Invoice, Schedule and Schedule Tomorrow (in both Simple and Tracking mode).
- Click Mark for Invoice. The button changes to ✓ Unmark for Invoice and the card's left edge turns teal.
- To take the mark off, click Unmark for Invoice.
- Click Schedule to open a calendar. Today is outlined; the current date for the job is highlighted orange. Click a day.
- A message confirms it (e.g. Scheduled for 10/21/2026) with an Undo button, and the date on the card changes.
- Click Schedule Tomorrow to put it on tomorrow in one click (message: Scheduled for tomorrow).
Good to know
- Jobs marked for invoice can be found with Filters › Needs Invoice.
- Scheduling sets the date shown on the card and the job's Due Date (in the demo, scheduling for Oct 21 changed the due date from Oct 23 to Oct 21).
- In Simple mode, scheduling also changes the badge to Scheduled.
- Past days are grayed out in the calendar.
If something looks wrong
- Due date changed unexpectedly: someone used Schedule or Schedule Tomorrow on the card; set it back in Edit (pencil) › Due Date.
- The message says "unmarked" right after marking: go by the button. If it reads Unmark for Invoice, the job IS marked.
Pull powder from the card
- Click + or − next to the powder weight on the card. A small Qty box opens.
- Type the pounds and click − to take it out of stock. Leftovers? Type them and click + to put them back.
- See Adjust your inventory for the other two ways to change stock.
Transcript
- Ready to bill it? Click Mark for Invoice right on the card.
- The button now says Unmark for Invoice. Click again to take it off.
- Click Schedule and pick the day you'll run it.
- The card shows the new date. Picked wrong? Click Undo.
- Schedule Tomorrow does it in one click.
- You can pull powder right from the card. Click plus or minus next to the powder.
- Type the pounds and click minus. Leftovers go back with plus.
See it on a real shop floor
Open the demo shop — no signup, nothing to install — or start a free trial with your own jobs.